2 files changed, 0 insertions, 69 deletions
diff --git a/examples/BlinkWithoutDelay/BlinkWithoutDelay.ino b/examples/BlinkWithoutDelay/BlinkWithoutDelay.ino
deleted file mode 100644
index 0143571..0000000
--- a/examples/BlinkWithoutDelay/BlinkWithoutDelay.ino
+++ /dev/null
@@ -1,65 +0,0 @@
-/* Blink without Delay
- 
- Turns on and off a light emitting diode(LED) connected to a digital  
- pin, without using the delay() function.  This means that other code
- can run at the same time without being interrupted by the LED code.
- 
- The circuit:
- * LED attached from pin 13 to ground.
- * Note: on most Arduinos, there is already an LED on the board
- that's attached to pin 13, so no hardware is needed for this example.
- 
- 
- created 2005
- by David A. Mellis
- modified 8 Feb 2010
- by Paul Stoffregen
- 
- This example code is in the public domain.
-
- 
- http://www.arduino.cc/en/Tutorial/BlinkWithoutDelay
- */
-
-// constants won't change. Used here to 
-// set pin numbers:
-const int ledPin =  13;      // the number of the LED pin
-
-// Variables will change:
-int ledState = LOW;             // ledState used to set the LED
-long previousMillis = 0;        // will store last time LED was updated
-
-// the follow variables is a long because the time, measured in miliseconds,
-// will quickly become a bigger number than can be stored in an int.
-long interval = 1000;           // interval at which to blink (milliseconds)
-
-void setup() {
-  // set the digital pin as output:
-  pinMode(ledPin, OUTPUT);      
-}
-
-void loop()
-{
-  // here is where you'd put code that needs to be running all the time.
-
-  // check to see if it's time to blink the LED; that is, if the 
-  // difference between the current time and last time you blinked 
-  // the LED is bigger than the interval at which you want to 
-  // blink the LED.
-  unsigned long currentMillis = millis();
- 
-  if(currentMillis - previousMillis > interval) {
-    // save the last time you blinked the LED 
-    previousMillis = currentMillis;   
-
-    // if the LED is off turn it on and vice-versa:
-    if (ledState == LOW)
-      ledState = HIGH;
-    else
-      ledState = LOW;
-
-    // set the LED with the ledState of the variable:
-    digitalWrite(ledPin, ledState);
-  }
-}
-
diff --git a/examples/BlinkWithoutDelay/Makefile b/examples/BlinkWithoutDelay/Makefile
deleted file mode 100644
index 3dea6c0..0000000
--- a/examples/BlinkWithoutDelay/Makefile
+++ /dev/null
@@ -1,4 +0,0 @@
-BOARD_TAG    = uno
-ARDUINO_LIBS =
-
-include ../../Arduino.mk