Move tests back to 'examples', skip non-testable examples when testing.

This fixes https://github.com/sudar/Arduino-Makefile/issues/259.

1 files changed, 0 insertions, 53 deletions

diff --git a/tests/AnalogInOutSerial/AnalogInOutSerial.ino b/tests/AnalogInOutSerial/AnalogInOutSerial.ino
deleted file mode 100644
index e142f69..0000000
--- a/tests/AnalogInOutSerial/AnalogInOutSerial.ino
+++ /dev/null
@@ -1,53 +0,0 @@
-/*
-  Analog input, analog output, serial output
- 
- Reads an analog input pin, maps the result to a range from 0 to 255
- and uses the result to set the pulsewidth modulation (PWM) of an output pin.
- Also prints the results to the serial monitor.
- 
- The circuit:
- * potentiometer connected to analog pin 0.
-   Center pin of the potentiometer goes to the analog pin.
-   side pins of the potentiometer go to +5V and ground
- * LED connected from digital pin 9 to ground
- 
- created 29 Dec. 2008
- modified 30 Aug 2011
- by Tom Igoe
- 
- This example code is in the public domain.
- 
- */
-
-// These constants won't change.  They're used to give names
-// to the pins used:
-const int analogInPin = A0;  // Analog input pin that the potentiometer is attached to
-const int analogOutPin = 9; // Analog output pin that the LED is attached to
-
-int sensorValue = 0;        // value read from the pot
-int outputValue = 0;        // value output to the PWM (analog out)
-
-void setup() {
-  // initialize serial communications at 9600 bps:
-  Serial.begin(9600); 
-}
-
-void loop() {
-  // read the analog in value:
-  sensorValue = analogRead(analogInPin);            
-  // map it to the range of the analog out:
-  outputValue = map(sensorValue, 0, 1023, 0, 255);  
-  // change the analog out value:
-  analogWrite(analogOutPin, outputValue);           
-
-  // print the results to the serial monitor:
-  Serial.print("sensor = " );                       
-  Serial.print(sensorValue);      
-  Serial.print("\t output = ");      
-  Serial.println(outputValue);   
-
-  // wait 10 milliseconds before the next loop
-  // for the analog-to-digital converter to settle
-  // after the last reading:
-  delay(10);                     
-}